EXISTING ADJACENT BUILDING INFORMATION

Form Revised 10-25-06

 

Contract No. :

 


Existing Building Manufacturer: _____________________________________________________


Old Heritage Job #: __________________


      ( Gable Building)             ( Single Slope Building)            


    Width: __________      Length: ____________      Front Eave Height: ____________      Back Eave Height: ____________
    (Eave Heigth is measured from Finished Floor to Top of Eave Strut)


    (Front Side) Roof Slope: _______:12              (Back Side) Roof Slope: _______:12  


    Existing Building Bay Spacing: _________ Bays at _________ Feet

  

    On What Wall does the Tie In Occur?       ( Front)       ( Back)       ( Left)       ( Right)

 

    Common Wall at the Tie In will be   ( Sheeted)     ( Open)


    Heritage to Provide Transition Trim?      ( Yes)     ( No)


    If the Existing Building is Currently Sheeted, Existing Building Girt Type    ( Bypass)     ( Flush)     ( Not Sheeted)


    Girt Depth: _________________                  Girt Spacing: _________________


    Wall Panel Type: ________________                  Rib Height: ________________


    Roof Panel Type: ________________                  Rib Height: ________________


    Distance between Existing Structure and the Proposed Building: ___________________


    Difference in Roof Height between Existing Structure and Proposed Building: ___________________
    (Snow Drift Will Occur if Difference is More then 2?-0?)

Image Image

Wall of Attachment is given Above.
Write dimension between dimension lines next to DIM. If Dimension is 0, Write in 0?. Locate Ridge on Drawing.